Инструкция к часам hyundai h 1547

Important safeguards

•The instruction manual contains important operating and maintenance instructions. For your safety, it is necessary to refer the manual. Keep the manual for use in future.

•Do not hit or drop the unit.

•Do not expose the unit to vibration,

direct sunlight, too high or low temperature or humidity.

•If you are not going to use the unit within a long period of time, remove the batteries to avoid their leakage.

•Do not disassemble the unit yourselves. Refer servicing to qualified service personnel.

Power supply

Battery operation

•Insert 1 battery Cr2032 (included) to the battery compartment (remove the screw). The set will not work normally from the battery supply, but there is now the advantage that, in case there is a mains current failure, your clock will continue to work. The clock display will not light up, the clock time will be held in the clock memory by the battery back-up system. This enables you to move the set from place to place without re-setting the clock every time. The battery back-up system is only meant to be used from short temporary power failures. For longer durations the battery may become exhausted or there may be deviation in accuracy.

•When the battery is exhausted, it should be removed from the set to prevent leakage. If you do not wish to take advantage of the battery back-up system, your set will work normally without a battery. However, if disconnected from the mains, the clock figures will flash when the mains are re-connected and you must re-set the clock.

AС operation

• Before the first connecting of the appliance

check that voltage indicated on the rating label corresponds to the mains voltage in your home.

•Plug the corresponding end of cord into the power socket on the rear of the set.

•Insert the plug into power supply.

Setting the clock

Set ALARM MODE switch to BUZZER position. Press and hold TIME button until hour digits flash. Press repeatedly /CLOCK/ ALARMand /CLOCK/ALARM+ buttons to set hours. Press TIME button to save hours; minute digits will flash. Press repeatedly /CLOCK/ALARMand /CLOCK/ALARM+ buttons to set minutes. Press and hold TIME button to save minutes.

Radio operation

Tuner operations

•Set ALARM MODE switch to RADIO position; the Radio indicator on the display will light up.

•Press TIME button to switch on the radio.

•Press RANDOM/SCAN button once to begin searching and saving of up to 40 radio stations automatically.

•Briefly press /CLOCK/ALARMbutton or /CLOCK/ALARM+ button to select previous or next preset station.

•Press and hold for 3 seconds /CLOCK/ ALARMbutton or /CLOCK/ALARM+ button for automatical search of the nearest station with strong signal down or up the range.

•Press PRE./TUN. button to switch between radio frequency and preset position; when frequency is displayed you can tune stations manually with/CLOCK/ALARMand/ CLOCK/ALARM+ buttons.

•To save a station, press and hold PROG button until display blinks, press /CLOCK/ ALARMbutton or /CLOCK/ALARM+ button to change preset position, briefly press PROG

button to save.

•Press repeatedly DISPLAY button; it will show radio frequency/clock time/alarm time.

•Use VOLUME regulator to adjust volume level.

•To obtain better FM-signal reception, extend the FM-wire antenna to its full length.

•To turn off the radio press ALARM button.

Sleep to music

The radio or MP3 (if a USB/SD/MMC is connected) can be set to play and to switch off automatically after a preset time.

•Slide ALARM MODE switch to a position to select MP3/USB/SD or RADIO to play.

•Press SLEEP button repeatedly to select the sleep time period (from 90 to 0 minutes).

•MP3 playback or radio will stop automatically after the preset time expires.

•To turn off the radio or MP3 before sleep time expires, press SNOOZE/SLEEP OFF button or ALARM button once.

Alarm operation

Setting the alarm

•Set ALARM MODE switch to Buzzer, Radio or MP3/USB/SD position to select alarm signal sound.

•Press and hold ALARM button until hour digits flash. Press repeatedly /CLOCK/ ALARMand /CLOCK/ALARM+ buttons to set alarm hours. Press ALARM button to save hours; minute digits will flash. Press repeatedly

/CLOCK/ALARMand /CLOCK/ALARM+ buttons to set alarm minutes. Press and hold ALARM button to save minutes.

•Press ALARM button to switch on or off the alarm mode. The Alarm indicator will light up when the alarm mode is on.

•To check alarm time press DISPLAY button.

Alarm sound setting

• When radio is selected for alarm sound, select a band, tune to the needed frequency

and adjust volume.

• When USB/SD playback is selected for alarm sound, ensure that USB or memory card is inserted and track playback is possible.

Snooze control

•When the alarm is on, press SNOOZE/ SLEEP OFF button once, after 9 minutes the alarm will be on again. This operation can be repeated several times.

•When the alarm is on, press ALARM button once to stop the alarm. The alarm will be activated after 24 hours. Press ALARM 2 times, alarm will be completely off and Alarm indicator goes off.

•When the buzzer alarm is on, if you don’t press ALARM button, the buzzer will turn

off after 2 minutes, then start again after 9 minutes. This will repeat 5 times or until you press ALARM button. When radio or MP3 alarm is on, if you don’t press ALARM button, it will stop after 90 minutes.

USB/SD/MMC operation

Playback

•Insert a USB device into the USB port or insert an SD/MMC memory card into the memory card slot.

•Slide ALARM MODE switch to MP3/USB/ SD position.

•Press TIME button to switch on the player. Playback of the first track contained in the USB/memory card will start automatically. MP3 indicator will be flashing.

•The display starts by showing total number of available tracks, then track number to be played for about 2 seconds each and for every beginning of a track. Press DISPLAY button

to change display in following order: total available tracks/track number/track current time/track remaining time/alarm time/clock time.

•Press PRE./TUN. button to pause playback. Press it again to resume playback.

•Press STOP button once to stop playback;