Инструкция к стиральной машине zanussi t845v

•When you receive your washing machine, unpack it or have it unpacked immediately. Check its general appearance. Make any reserves in writing on the delivery form and keep a copy.

•Your washing machine was designed for use by adults. Make sure that children do not touch it or use it as a toy.

•Do not modify or attempt to modify the characteristics of this washing machine. This could be dangerous for you.

•Your washing machine is intended for normal domestic use. Do not use it for commercial or industrial purposes of for any purpose other than that for which it was designed : to wash, to rince and to spin.

•Unplug the power suplly plug and close the water supply tap every time after using your washing machine.

•Only wash articles that can resist machine washing. Refer to the instructions on the label for each article.

•Do not wash underwear with bones, or any material without hems, or torn materials in your washing machine.

•Remember to remove all coins, safety pins, boraches, screws, etc., before each wash. They can cause serious damage if they are left in your washing.

•Do not put articles in your washing machine if you have used a solvent, alcohol, trichloroethylene, etc., to remove stains from them. If you must use these stain removers, wait until the product has evaporated before putting the articles in the drum.

•Collect all small articles such as socks, belts, etc., in a small cloth bag or pillow case.

•Use the quantity of detergent indicated in the «proportioning of detergents» section.

•Always unplug the washing machine before cleaning it and doing any maintenance.

•This washing machine is heavy. Take care when moving it.

•You must remove the packing on the washing machine before use. Failure to remove all transport protection devices can cause damage to the washing machine or nearby furniture. The washing machine must be unplugged while packing is being removed.

•Do not allow any one other than a qualified plumber to make the hydraulic connections necessary to install your washing machine.

•The washing machine must be plugged in to a power outlet with a conform earth.

•Call a qualified electrician if the electrical installation in your residence is such that you have to modify it before you can connect your washing machine.

•Please read the instructions in the «electrical connections» chapter carefully before connecting your washing machine.

•After installing your washing machine, make sure that it is not standing on its electrical power supply cable.

•When your machine is installed on a carpeted floor, make sure that the carpet does not close off the ventilation openings near the bottom of the machine.

•The power supply cable may be only replaced by the After Sales Service.

•Your manufacturer cannot be held responsible for any damage resulting from a nonconform installation.

146 5343 00 — 09/03

3. INSTALLATION

3.1. Unpacking

Packing used to protect internal parts of the washing machine during transport must be removed before the washing machine is put into service for the first time.

Remove all packing from the washing machine. Tilt the washing machine sideways and then remove the packing under the motor, and straighten the washing machine.

Tilt the washing machine backwards, rotate it by a quarter of a turn on one of its corner to remove the transport base.

Open the washing machine lid and remove the immobilization packing and plastic films.

Close the lid.

Use a 10 mm spanner to remove the two screws and spacers at the back.

You can now see the openings that must be closed with the caches in the pack attached to the washing machine; do not forget to fold down the central capsule.

Make sure that you have removed all these parts from your washing machine and keep them so that you can use them again if you need them for future transport.

If you want to keep your washing machine aligned with the adjacent furniture, you can cut the pipe support strip at the back of your washing machine. Leave the two side closers in place.

3.2. Position

Put the washing machine on a flat hard floor in a well ventilated room.

Make sure that your washing machine does not touch the wall or any other furniture in the room.

3.3. Moving your washing machine

If you want to move your washing machine, lift it onto its rollers by pulling the lever at the bottom of the washing machine all the way to the left. When you have put your washing machine into the required location, put the lever back into its

initial position.

3.4. Leveling

Precise leveling will prevent vibrations, noise and movements of the washing machine during operation.

Make the washing machine level by adjusting the leveling screw that is

too short.

Unscrew the stand and locking col-

lar assembly (lift the washing machi-

ne if necessary).

When the washing machine is stable, maintain the stand on the ground and turn the locking collar as

far as posible.

3.5. Water inlet

Screw the supply ppe con-nector onto the water inlet tap (20×27 mm), remembering to use the washer provided with the washing machine.

Open the water inlet tap.

You cannot prolong the water inlet pipe. If it is too short, buy a longer pipe provided for this purpose.

3.6. Drain

The drain siphon must be placed inside a drain pipe (or in a washbasin) at a height of between 70 and 100 cm. Make sure that it cannot fall.

•Important: the drain pipe must never be prolonged. If it is too short, call a professional.

3.7. Electrical connection

You can only connect this washing machine to 230 V single phase power supply.

Check rating of the fuse line: 10 A at 230V.

The washing machine must not be connected through an extension cable or a power bar.

Check that the earthing connection is conform with the regulations in force.

grammes. These spinnings are reduced for the synthetics, wool and delicate cycles.

4.2.4. Choice of the temperature

Choose the wash temperature applicable for the selected program (using the information given in the programmes table) and comply with the temperature shown on the care label for each article to be washed (see the washing guide).

4.2.5. Choice of the pushbuttons

Press the chosen pushbuttons.

4.2.5.1. «On/off» pushbutton

To switch on your appliance, press this pushbutton.

4.2.5.2. «Half load» pushbutton

This pushbutton allows to wash small quantity of linen not much soiled (max. 2,5 kg) on cotton programmes only by reducing the water quantity during rinsings.

4.2.2. Proportioning of detergents

Your washing machine was designed to reduce water and detergent consumption, therefore reduce the doses recommended by detergent manufacturers.

Pour the powder detergent dose into the wash compartment and into the prewash compartment if you chose the «prewash» option. Pour in the softener into the compartment if you wish.

If you are using a different type of detergent, refer to the «detergents and additives» section in the washing guide.

4.2.5.3. «Rinse plus» pushbutton

This option adds more water in rinses on Cotton programs. It is advised for allergic people to detergent products and in areas with fresh water.

4.2.6. Choice of the programme

Select the programme depending on the nature and the degree of soil of the laundry.

Turn the programme selector clockwise to select the chosen programme.

4.2.3. Choice of the spinning speed

Choose the spinning speed which corresponds to the nature of your laundry and to the degree of humidity wished at the end of the wash.

The knob indicates the possible spinnings on the coton pro-

4.2.7. Starting the program

After you choose the washing program, press the «On/Off» pushbutton to start the cycle.